Turbo TImer HELP ASAP

[TalonRacer024]

Well the steering colom cover is off and i have no clue where to connect the wiring harness for my HKS Turbo Timer type 0. Both ends. I also need to know where the RPM signal wire is and the e-brake wire is. I have a first gen and the VFAQ is for a second gen. PLEASE HELP MY CAR NEEDS TO BE PUT BACK TOGETHER SOON.

 

[jdmawd]

Originally posted by TalonRacer024
Well the steering colom cover is off and i have no clue where to connect the wiring harness for my HKS Turbo Timer type 0. Both ends. I also need to know where the RPM signal wire is and the e-brake wire is. I have a first gen and the VFAQ is for a second gen. PLEASE HELP MY CAR NEEDS TO BE PUT BACK TOGETHER SOON.

put the column back together, the connector is under the floor vent duct. there is a seam in the two pieces that will expose two sets of connectors. one is clear the other is black and blue(you want to connect the black and blue one to you're TT harness). it sits behind the clear connector you have to reach up a bit to grab it. the e-brake wire is at the bottom of the e-brake handle it should be green. the rpm signal wire is at the ECU its black but use the vfaq pin out as a reference because there are more than 1 back wire at the ECU. use www.vfaq.com in the electrical section for the ecu pin out diagram

 

[Niknuk]

Hey thanks, I had no clue where to find the wires to hook up the harness or to tap the ECU. I also had the steering column cover off :
After reading these few posts it only took me 3 hours! to get the thing on. But its on and working!