ideas!!!

[Moorepwr]

I have extreme turbos 3" O2 elim. back exhaust. Its ran same as stock (fwd) and were it runs between the spare tire housing and rear axle it seems to vibrate at certain rpms and at idle. Now theres only about a 1/4 inch of space left on both sides and the exhaust is tight because I checked again. I was thinking of wraping heat wrap around that part but I'm up to some more ideas.

thanks,
jason

 

[candela]

Rear axles.... dont you have a gst
I have the same problem as well as it sitting a little to low (the muffler) I just tied wire around the hangars and little flanges on the exhaust to "stiffen" it up a bit. It now looks a little btter and doesnt vibrate anymore. I used to get on it and as soon as i woudl back off at high rpm's the exhaust would rattle... not no more

Austin