Blog Title: turbosax2
My Fuse Box Relocation and Cleanup Project - Part 21
Posted 09-24-2008 at 08:08 PM by turbosax2
Not too much to update today. I took all 4 mud flaps off. Underneath one of the rear flaps, it looks like it rubbed against the bumper so some paint was worn off I'll have to get some touch up paint to take care of it. I polished my hood prop and my brother's too, turned out pretty good. I didn't go for a mirror finish, just polished a little so it looks kinda shiny. I tested them before and they're SS so they won't rust. Put the new hatch struts on. Found a few more bolts and such I want to order from Mitsu. I'm going to put the ECLIPSE logo back on tonight. I think I found a good solution for the rear carpet, just need to get some material. That's it.
Can anybody think of a clean way to block the holes in my firewall? I need to close the holes that were used for the heater hoses, a/c lines, a/c drain vent etc. Ideally I would weld them shut but that's not an option. What do you guys think?
The only thing I did this weekend was shave my 1g throttle body. It needs welded and blasted, then I can rebuild it. I lightly polished it to check for major imperfections.
I didn't get to do anything else because my friend and I started building a blast cabinet. We're not done yet but here is a teaser shot.
Can anybody think of a clean way to block the holes in my firewall? I need to close the holes that were used for the heater hoses, a/c lines, a/c drain vent etc. Ideally I would weld them shut but that's not an option. What do you guys think?
The only thing I did this weekend was shave my 1g throttle body. It needs welded and blasted, then I can rebuild it. I lightly polished it to check for major imperfections.
I didn't get to do anything else because my friend and I started building a blast cabinet. We're not done yet but here is a teaser shot.
Total Comments 4
Comments
-
Now do like Mr. Peepers! What a great looking cabinet!Posted 09-25-2008 at 11:00 AM by OddNotion
-
I'm hoping my friend and I can almost finish it this weekend. I really gotta finish this so I can get all the pieces done to assemble the engine.Posted 09-25-2008 at 12:04 PM by turbosax2
-
dont you need those 3 things that the vacuums lines connect to above the throttle body? how do you avoid using them cause it looks good what you did..??thanksPosted 01-09-2009 at 12:52 AM by jen_cairo
-
They're just for emissions stuff. I got rid of all emissions equipment so I don't need the nipples anymore.Posted 01-09-2009 at 07:08 PM by turbosax2
