Blog Entries

I installed the oil pickup/pan yesterday morning. I picked up some 6.0mmx1.0x30mm studs and some flange nuts to install the pan with. It made it a lot easier to get it aligned without making a mess of the RTV.



I used Right Stuff grey for the pan. The caulking gun tubes are really nice and would recommend...

I think this might have been a better avenue for sharing this build then just putting it in the cylinder head/shortblock section.

I will be posting the updates/photos from the original build thread in this format.

Thanks for looking!

I won't be posting up a picture of every nut bolt and screw but I will try to make this a semi-informative thread that...

I've been busy the past 2 days because I got my engine back from the shop. The block had been machined and built (Wiseco pistons, 6 bolt rods, BSEK) but the head hadn't been touched and still needed to be cleaned out before I could reassemble everything.



I removed the camshaft bearing caps, camshafts, rocker...