- turbo install
- do i need an egt
- high reving
- got some Custom work back today
- boost cut
- boost controller
- Check this out: Project Eclipse
- 1g in a 2g
- 17c turbo?
- [RESOLVED] homemade exhaust?
- Hks Hiper Exhuast
- Greddy Turbo Timer features?????
- fpr
- Which Pistons Should I Use?
- installing a 2g mas on a 1g
- Must VENT
- O2 sencer housing
- Set up Questions
- Cruise
- Where can i get an ACT 2100 clutch kit for the least amount of $$$
- Why a DSM?
- big parts list install need help!
- Furture upgade plans. Suggestions.
- 14B Upgrade
- lifters
- switching turbos
- Question About Fuel Pump
- getting a turbo to match my mods
- NT 4G63 in my TSi
- this does NOT look right!! lol
- Greddy Uicp?
- Fmic, Uicp (wtf)
- witch intercooler for a 95 TSI
- FMIC Pipe Size
- Muffler Illegal in NH!
- Fluid from clutch pedal
- Intake Pipse size and BOV sound
- Engine question
- take care of fuel cut in advance? or wait for it first?
- Spearco 3-105 core
- Turbo Timer Installation
- Rebuild or buy Built?
- Crower Cams
- VR4 190lph Fuel Pump Install help.
- Dodge and Eagle owning the track, Damn Domestics
- How to find out what bearings I need?
- Question about 2G MAS
- Fuel upgrade question?
- Evo V 560cc injectors
- Looking for best price for Big 16G
- Big 16g to 20g conversions
- Pistons and rods...
- Greedy BOV Q
- Need help from all DSM family!!!!
- RNR 3" Catback, or Apex N1?
- Fidanza Flywheel?
- EGT install help
- mbc on ebay *just want opinion*
- 95 pistons or forged?
- The truth about the exshaust ground strap!?!
- engine Identification
- please help! can't find dimmer wire in2G
- big 16g & 18g
- Average cost to do the 6bolt swap?
- Do you think it's worth getting the AFCII for a 2G
- FP-30 release.
- Need help on removing 2G ECU
- BOV question
- about boost
- Changing Clutch
- BOV question
- swapping parts from GSX to TSI
- 50 trim t3/t4 rec. timeslip?
- 4g63 in a mirage??
- BOV before boost gauge?
- 4g63 block
- What do yuo think of my FUTURE setup?
- Forced performance green
- flooded with fuel question
- It's Alive!!
- Is this everything?
- Turbo Advice: AGP L2 or SBR G50?(LONG)
- Engine pulling question?
- 1G and 2G head differences
- OK, this may be a little different. (6-bolt question)
- oil supply line
- fwd traction
- HOW DO U HAVE YOUR GREDDY BOV SETUP (16g/B16g/TD05 OWNERS)
- dyno prices
- clip, just port, or t3 compressor wheel
- different between 1g and 2g 02 housing?
- Walbro 255
- My new engine installation PICS
- 660 cc
- Bov
- Reasonable Price Wideband O2 tuner
- non turbo fuel pressure regulator
- Looking for a Factory Repair Manual
- intercooler noise
- Messed up my Head, what are my options?
- Anyone ever use a 16G Killer on a 1G car???
- 16G turbos
- FMIC's and Cutting
- Boost ?
- O2 Elim DP or Ported O2 housing then DP?
- Are these things normal?
- Awd Burnout
- Questions about the TD05 20G.
- speed limiter
- Help on Fmic installation
- Blown Engine
- cam math. question
- Upgrades, Injectors and TB for 2g
- How efficient is APG L2R with 34mm int. gate?
- 3000gt fuel pump
- Hks 264/272 cam equivalant
- 6 bolt 7 bolt??
- removal of valve springs
- Pics of my Galant block honing.
- Crazy boost levels?
- Starting to get a headache...need some help
- more info on big t28 killer
- Injector Size Recommendation?
- RNR 3" O2 Sensor Housing?
- Supra mkIV intercooler??
- AVC-R - Help!?
- Can you name this turbo?
- What next??
- mounting manual boost control inside ?
- Type S BOV Problem
- 1st gen cbv (bov) w stock piping fit on a 2nd gen stock uicp?
- Proof for a Walboro
- GT25 or GT30
- hks ssqv question
- jdm motor
- DYNO Numbers
- Turbo gaskets, needed at all ?
- Exhaust...am I missing anything....
- o2 Housings
- was it wrong to go with 2.5"
- Removing 02 sensor
- replace fuel pump or not?
- tial bov
- Recirculating The Hks
- difference between 1g and 2g fuel rail?
- question about check engine light
- O2 eliminating downpipes
- XS engineering 16g killer turbo -
- help with fuel pump
- porting 14b Q's
- Warped head
- Phantom Roadworks?
- would gasket in a tube work?
- looking for Garrett 4 bolt 3" o2 housing
- L2 turbo
- tso4 vs. to4e
- how can i remove the rev limiter w/o a TMO ECU?
- Screw and boost
- evo pistons? are they worth it.
- Is this crankwalk?
- dual or single boost controller
- Can someone explain to me the "Intercooler Efficency" in this link?
- Datalogged the ol car...
- 14b Situation
- Turbo Timer question
- What are the parts for HomeDepot Intake?
- 3000gt Bov
- Pics of new turbo
- fmic ???????
- Intercooler suggestions
- is it me???
- early 1G rods and late 1G rods- question
- I'm going crazy trying to pick a turbo!!
- Got my L2R, Have Exhaust Questions...
- Apex-i Front mount intercooler
- piece of plastic fell into timing belt area..
- pics of Apexi WS on my 1g (56k warning)
- Engine mods
- Need expert Help for building up a 6-bolt and choosing a turbo
- How to identify cams?
- Turbo Question...
- Looking For The Angle'd Exhuast System
- Boost 'sag'?
- Hissing????
- Best BOV for venting /w VPC?
- Any more creative "free" mods?
- Turbo Swap
- IC pressure drops and loos of power with FMIC
- UICP ? (not repost)
- Garrett T04B
- 14b Questions
- I just bought a front mount !
- People with FMIC, any drivability issues?
- Low Hanging Exhaust
- mustang throttle body
- pump gas or race gas
- My Battery Continues To Go Dead!
- Porting Tools [Merged 3-8] Tool die grinder Dremel
- Help with timing belt Q?
- help me be the king of new york
- A to F gauge accurate??
- pwr liquid to air
- Engine swap
- Dyno
- 1st gen stock turbo cam specs
- cracked exhaust manifold help
- Need help with strange knock!!!!
- To bore or not to bore?
- dyno 2000 4g63 profiles
- Igniton!
- cam gears
- intercoolers
- turbo timers and Boost control
- Boost leak or Creeping
- Head Gasket price for 96 turbo
- down pipe question
- Silencer Removal
- An idea & question
- o2 and manifold Questions with apex n1 turbo-back
- Any buy from Turbochargers.com
- how much boost
- My first Dyno Run
- 90 gsx head on a 92 tsi
- What kind of turbo do I have? 14G or 16G?
- $459 for 4g63 rebuild kit worth it?
- The Official Thread
- Question about my set up ....
- Replacing Bent Valves
- Camshafts
- intercooler piping question
- questions about 1g and 2 g blocks!
- Need some input.
- loud clicking noise coming from motor
- supra smic
- Exhaust
- How much air are you flowing
- Apex'i AVCR and other questions
- Switching to 2g MAS??
- Engine Swap?
- Exhaust
- installing a turbo
- head stud tightening pattern
- Do you run over 25 pounds of boost?
- autometer
- Question about bent axle
- Turbo question!!!!
- $17,500 to run 10s is it to much
- 4 bolt rear end
- How to tune a type s?
- Which intercooler is like this: