View Full Version : Newbie Forum
- Used tubro wastgate question
- Aeromotive compact fuel pressure regulator questions.
- Greddy Profec B Spec II
- Need Alarm Wiring Help
- Question about changing brakes
- Question about dents in my pistons
- stripped transfer case threads (will it leak?)
- Galant RS Oil Filter Assembly
- 1g, 7bolt question....
- Shift problems
- injector ?
- turbo replacement vender
- Vibrant 4.5' MAF adapter + cone fitment Q
- HKS Fuel Cut Defencer.. Keep it?
- Anyone using this manifold?
- What Could Be Causing this?!?
- need help with AFC2 on 1g ... Adding +30 just to get 12.0 a/f on wideband
- I need some DSM advice replace Tranny or diff
- [RESOLVED] With a ball and spring type mbc how does the pressure escape?
- Front diff help
- is 4g63 same as4g63t?
- head gasket
- Exhaust bolts on cat flange?
- diy mbc problem.
- New clutch
- 1 gen/2 gen SMIC?
- tranny help
- Got my first DSM :) 97 GST! Time to do a tune up!
- 16g manifold spacer
- Need some advice
- sputtering, bad idle, and almost dies
- ECU Harness connector
- 1g Fuel tank New $900.00
- Push start / start from engine bay?
- Headlight wire harness
- Adjustable timing? Auto Trans issues
- New Car - 91 GSX Maintenance Parts
- [RESOLVED] Help Installing Eprom ECU
- Is this a 14b or 16g?
- new setup very high oil pressure
- Engine Rebuild , need advise
- Electical F Up
- What thrust bearing do i have?
- what next
- Tmo
- turbo rebuild shop on long island??
- Help Hardwire 1g MAFT on 2g
- Turbo Whine
- Any difference between these gauges?
- FWD Engine in the Rear Questions?
- no power
- 97 gst...:(
- 2G awd wont start.... need help quick!!
- Buying a used AWD tranny what should i change?
- Hard Piping Worth it?
- i searched. but cant find it.. max boost on fpbig28?
- Upper Control Arm Mount Rusted through!?!
- Quick question about ebay maf adapter and filter
- help with oil pan gasket
- wanna put a 2G turbo motor in my 1G turbo talon help
- what throttle body should I go with?
- A few rebuild ?'s
- Turbo Cat back
- 6 bolt wont rev/idle for crap.
- Get a 6 bolt or keep the 7?
- Gaskets, Seals, Pumps, where?
- 13.5 peak voltage?
- hahn 16g boost controller
- Windshield washer tank help on a 2G AWD
- Crank Pulley Bolt Length?
- Removing Head: Head Stud Question
- 1g 7bolt questions (and more)
- Sputtering and cutting out
- Tranfer case 94 eclipse dimensions
- Gas Gauge not working?
- 2G 7 Bolt Build
- 6 bolt swap intake question..
- greedy full turbo timer
- Has anyone seen a front o2 read 1.10volts all the time?Wiseman please
- safc
- E85 vs. Methanol
- fuel cut??
- Tuning?
- Almost gave up
- Cheaper to make own oil lines or buy from vendor?
- sbr 3500 clutch with my setup?
- Vibration in Steering wheel at highway speeds
- Oil Cooler Question
- Fuel pressure solenoid question
- cranks but wont fire...
- Replacing temp sensor
- Will 17x9 fit?
- Take a look at this turbo please
- Permatex cup&core
- Shopping for 1g exhaust
- Lots of maintanance. Still running funny.Log and pics. Pleas help
- question about how much boost.
- new engine has some problems
- Are t3/t4 cast exhaust manifold any good?
- Several Problems
- Ticking That Doesn't Go Away?
- i need help to remove my oil pan
- 6 bolt rod and main bearings.
- Oil pressure gauge installation
- Help! Need IC pipes that fit
- Stock GSX 16G upgrade?
- 2nd gear lurch?
- NEW alarm problem; time related
- 7 Bolt Builds...
- How often should one replace the Oil cooler!
- dsm graveyard's Frankenstein shortblock?
- who's intake manifold is this?
- Switching to air to oil housing set up (90 oil housing and cooler)
- Timing Belt Install
- tial wastegate question~
- 1g mas - 2g mas
- fluidampr vs ATI super harmonic balancer??
- Unsteady RPM's
- UPC Polished Tubular Header
- Diagnose ABS problem
- [RESOLVED] question about the block
- clutch
- Motor dies after I've disconnected the battery
- Newbie meth question
- ran my power wire for amp and engine fed?
- wont pass inspection? (New York)
- heated oxygen sensor
- First starting the car.
- calibrating wideband
- 16g boost controller
- N/T Rad?
- Four Wire CAS
- Need someone to double check the time on my car?
- viper alarm question
- [RESOLVED] Radiator crack- repairable?
- Ebay Turbo, I know its been covered....
- bell housing
- Help! Mechanic near Milwaukee, WI`
- just need some tips/advice on tune-up/maintenance
- Turn ES Bushings into 2 piece?
- overheating help
- eprom ecu
- Fuel lines on catch can
- Rusted Apexi Exhaust tip
- Dropping tranny for the 1st time, 90 awd.
- What can cause a starter relay to blow
- Preswap Checks....any suggestions
- Tranny question
- ACT lightweight flywheel - burn marks
- Replacing TB to Intake Mani gasket require complete removal/disassembly of the TB?
- front case plug... metal or rubber
- Internal Wastegate from hell
- Filter Bag
- Help Gauge A/f Connection!!!
- changing alternator on a 1g turbo talon
- 95 Eagle Talon Tsi Expert Needed!
- Need help with AFCs and such...gettin' confusing!
- ok i need help asap. with this safc
- Is it time for a rebuild? Compression/leakdown/BLT
- [RESOLVED] whats worst running lean or rich?
- Car lurches after turbo install
- Could it be my timing?
- Keep Blowing Turbos......
- 14b with external wastegate
- would it be the same as a turbo engine
- Speed Sensor hookup on conversion??
- Copper Washer Size for Water Lines/Tubes
- Ned help car died turbo glowing
- 1g maf
- 02 housing flange
- GST oem rim price check
- 2 Fuel pressure gauges?
- Smooth Rides
- 3 inch intercooler pipe too much?
- bt28/safc/meth
- Wont start!!
- 6 bolt rebuild
- Transmission Rebuild - Aftermarket or OEM?
- Clutch Adjustment Rod
- JIC FLT-A2 Noob question
- how to tell what size my injectors are..
- Oil feed line is leaking.
- FWD Rear Sway Bar End Links
- Synapse ajustable fuel pressure regulator
- AVC-R Max Boost?
- Clutch assembly
- Dsmlink log Is my O2 sensor dead
- 6bolt nt motor in a 95gst
- fan wires getting no power
- tokico hp height issue, im stumped help
- 6 Bolt/7 Bolt Gasket Sets
- setting a NXS MBC to 15psi
- Stage 2 Clutch Issue
- RPM vs MPH on gauge cluster....(i took mine appart need numbers please )
- turbo a non turbo 1.8?
- DSM Emissions are Killing Me!
- 550cc injecters
- AWD Trans Troubles
- Rough Idle?
- Blown head gasket.. or not?
- 90 Laser , Wont rev passed 5 1/2
- Mitsubishi Timing Belts- MD182291 or MD326059?
- car jumps in reverse
- so i have to replace my water pump.
- Wierd Problem CEL code 22 Crank sensor?
- Car seems slow with bov return.
- problems problems problems need help
- 6 bolt swap dont run right
- cruise control
- GST Exhaust on an GSX!
- hot vs cold
- Help! purchasing race motor..
- Smoking at idle, please help...
- Please help me with SI Dual Springs w/ Manley Titanium Retainers
- [RESOLVED] exhaust question 2.5in or 3in flange?
- Losing Coolant, not overheating?? IDEAS
- Pan leak
- Wastegate Flapper Not Shutting all th way 14b
- Any Fellow Dsm Owners Attend The Mopar Nationals???
- [RESOLVED] Need Rear strut picture (and CAPS walkthrough)
- Alternator Wiring Problem
- filter help!!!!!!
- ebc rotors
- belt slipped, or something
- Sputtering only around 3k rpm
- [RESOLVED] what fitting size to use
- 4g64 2.4L head swap
- [RESOLVED] Which car is this manifold from?
- Is this 16g upgrade kit worth it?
- turbo kits for a 92
- Ecu swap questions!
- Heater stopped working and overheating! Please help diagnose problem
- Some newbie questions
- Boost/Timing Question With 14b
- composite fuel rail
- Are these struts good?
- need electrical help!!
- oil leak around oil cooler
- jdm ignition wires
- 98 Gst Whats Wrong With It?!?!?!?!?!?!!!?????
- Where to find Spyder hardware?
- Can't seem to get the car to idle
- Can the Input Shaft Sleeve be welded back on?
- too lean
- 6 bolt swap help. cas starter problem!
- Looking for direction
- possible oil leaks behind engine bracket
- installing halo lights 99 eclipse
- 6 bolt swap help. cas starter problem!
- iPod Touch