- head parts
- ?? about Hahn off rode pipe
- Need help Im hitting 15psi but fuel prob
- oil return tap
- What do I need for 20 psi?
- 8 injector fuel system
- I need help again after installing my 440's
- Is this right about my fuel and boost
- help with sfmu peices
- fuel filter
- GT30R & tune or Megasquirt!!!
- CEL -Rear o2 and incorrect gear ratio?
- Map sensor question
- Boost Control!
- 97 GS: 420AT or 4G63T? '???'
- Installation of my turbo stuff
- AFPR kit
- Downpipe>Exhaust
- Turbo Manifold
- Custom Turbo kit.
- Tubular Manifolds Cheap!
- motor mounts
- transmission
- Custom DP
- fuel pump
- Idle surge!!! & Idle fp w/ 550cc's?
- MSNS Update!!
- portfueler,ignition
- head gasket good enough?
- FMIC fitment
- Kit or Custom?
- Opinions for new clutch
- turbo
- custom 2gnt parts ???
- turbo specs
- max boost with my setup
- Another fuel cut question
- Zeitronix Installation
- -6AN Fuel Rail Inlet adapter for 420a
- Got her back from tuning!!!
- intake manifold and fuel
- Tapped wrong source
- Can't hear it spool and no boost..
- turboing my 420a
- 420a Stroker?
- Tuning SAFC Hi & LoThrottle
- IC pipes
- Engine comin out!
- slowboy says SAFC?
- removing fmu...where do the fuel lines go?
- just a few numbers
- Where to find stronger timing belt?
- Problems due to egr?
- idle problems
- need help w/ custom turbo setup..
- FMU Boost source question
- final steps for turbo
- Back in business
- t3/t4 turbo
- Tiny clip of my dyno pull...
- Use AFPR As Gauge?
- Not Boosting Correctly?
- dual side mounts?
- Aeromotive AFPR
- A taste of whats coming...
- will a 3in exhaust for a GSt work on my turboed N/T?
- Questions on Modding the 14b wastegate
- 255 walbro and 12:1 vortech
- 3 inch downpipe
- looking for a base map
- New Fuel Controller (XFC - Xtended Fuel Controller)
- where to tap?
- best egt spot?
- Putting One Of the 3g RX-7 Twins On My ESi
- 420a, 16g oil feed install qestion
- axles
- Knock Sensor on 420a
- what axle better and stonger?
- 97 N\T to New Turbo Engine. What to do ? Where to look ?
- Serious Question
- Tools Needed to Turbo? Or Pay Someone?
- Thought it was missing link... but i guess not
- 2G N/T Boost Control
- stupid me, the catalytic covertor I got off eBay is the wrong size.
- where to buy a missing link
- need help bad
- ss braided oil return line
- just wondering if anyone has ordered anything from here.
- Custom turbo kit need some assistance
- Thermal Coating
- Cracked Downpipe. Ok to drive short distance?
- 420a turbo manifold
- this is interesting thought i would let you guys in on it
- Should I finally Sell my dsm
- Turbo Fuel Pump
- sfmu question
- Boost problems...
- 14b ?
- Boost Leak?
- psi in a 420a
- XS Power turbos?
- logging 420a
- MLS gasket
- NT's/ turbo: 1/4mile times and Dyno #'s
- Turbo question
- can I use these injectors
- Another Portfueler question and i did search!
- Need some Engine/turbo help
- Hahn Kit
- Turbo/Intercooler piping for a rs
- Gas mileage and turbos
- I blew up thread part Deux
- Car still smoking
- "Extreme" Turbo Kit? (www.turbo-kits.com)
- i just blew up too.
- First Xmasta now me
- Another Turboed 420a
- dyno my car yesterday
- exhaust cutout
- missing link, still fuel cut.....???
- Turbo 420a
- New turbo, new problem....
- SRT-4 injectors will they fit?
- haltech wiring help
- What parts are needed for this setup?
- 2G Turbo conversion Checklist
- adding a turbo to a 420a 2G
- How to make E-manae work with OBD2
- oil cap
- LC-1 or LM-1 with E-manage and Greddy E-01 Boost
- Wideband goes to lean at 5500rpms (using SAFC2)
- Just called HRC...
- S-AFC or E-manage?
- Spark Plug help
- 420a mtor
- Oil Return on the 420a
- Does this sound right?
- tubular exaust mainfold
- Official I need a good realiable clutch Thread
- Why are N/T Turbo's So Slow in the 1/4 Mile?
- It has begun...temp rebuild in progress
- ive had it!
- if your turbo and a 420a might want to watch something.
- Why 95's do not need modification to MAP sensor for boost.
- Blew my motor
- howell create motor monster
- oil pressure
- Emanage support tool weighs 81lbs?
- megasquirt vs emanage
- 14b or t25
- 8psi-laughed upon
- Pistons and Rods
- Suddenly got thinking about converting
- new problem
- Summer of set-backs finally progess
- my car wont start!!!
- cant get the rpms down.
- coolant leak from under tranny
- Turbo 420a
- It's on like Donkey Kong....another RS+T thread
- What is up with my boost gauge!!?!?!
- 420aT reliablity
- Ran my 4G64 Spyder on the dyno
- What Do I Do Next?
- Top End Rebuild Question...
- BOV flutter
- Going with E-mange
- crack in the mani
- blow off valve
- engine hiccup
- Not that anyone cares..But i've ALMOST got my BOOST!!
- Vr4 crazy
- NT Block Forged Rods/Pistons FP3065
- Dual Circuit Oil Cooler - Pictures
- Cold Air Turbo Intake Pictures
- missing link question
- N/T Manifold Boost Tap
- Greddy E-manage
- Swap, or turbo kit?
- Worth Buying?
- How much boost with small mods
- injector size help again
- how much boost can i run without hurting motor for everyday use
- This is a killer bunch of question for the type of person who has done it a
- FMU or other option?
- Pic Request
- Weird exhaust leak?
- Turbo - Non Turbo Swap
- it lives!!!!!!!!!!!!
- How much of a power loss
- Boost control help
- Master Performance Engine Rebuild Kit
- wastegate and injectors questions
- overheating maybe???
- tuboed 4g64: momentary idle drop after rev
- clickin under vavle cover
- Whats it like after a bottomend rebuild?
- engine swap wiring issues
- Do 2g Non Turbos Have Fuel Cut
- Some pics of the Turbo kit on car.
- Quick Question about Rebuild kit.
- Another question but about boost
- A good clutch assembly for N/T turbo conversion?
- How to tune w/ bigger injectors, SFMU, and SAFC2?
- engine rebuild problems
- How much can a NT engine withstand?
- and another N\T has joined the Brotherhood of Boost :)
- Walbro fuel pump
- quick Turbo Timer question
- Oil Leak and fuel problems
- crank balance question
- FMU install ?'s
- Another turbo 420a
- msd coil pack question?
- Star T3/T4 oil outlet gasket
- couple of questions on the ggsx swap to get her running
- Good Product or no?
- how much psi on a stock 420a?
- Any one know if this is a good FMU??
- are turbo and n/t harnesses the same
- Finally boosted
- Question about a Larger Fuel Pump
- Anyone know if this oil line kit will fit a 14B?
- How much trouble...
- How hard is it really???
- Downpipe question
- Can I use hi-impeedence injectors on my 4G64T
- Questions before I head the the dyno tomorrow?
- 14B water and oil lines WHERE DO I FIND!?!
- just got my engine kit who wants to help?
- Topic name goes here... read red text below
- Bumper Modification
- Car dies, need help!
- 6bolt n/t to turbo swap in a 2g
- what is the best drill bit size for oil return.
- My friend's custom kit on a 95 esi
- Question for anybody
- Swaping a 4g63 non turbo in talon tsi fwd
- turbosmart mbc adjustment
- i need Engine Swap HELP
- oil feed question
- vj14 turbo on a 420a?
- HRC portfueler kit
- sfmu = how much boost
- 95 420a turbo owners
- Anyone have trouble with the turbo position from that ebay kit?
- Went to track today
- walbro fuel pump
- RPM Signal for E-manage
- Resistor Pack