help degreeing a cammed/stroked motor

[khartley]

I am fulling building this motor. I have Comp serious street cams (250/251) with hks gears, and a 2.3 bottom end. I have a huge FMIC if that makes any difference, all my mods are in my profile.

Dyno time is out of the question, the nearest AWD dyno is a state away.. about a 6 hour drive, and I guess I don't trust the car to get me that far. Wyoming sucks

Comp grinds all their cams to be 4 degrees advanced, according to their paperwork.

I also read that I could use my stock cams with a 2.4 crank by messing with timing a bit.

Anyone have any info or suggestions, links, personal experience, or anything to help me out? Thanks.

 

[KFT0001]

http://www.dsmtuners.com/forums/cylinder-head-short-block/314111-cam-degree-degreeing-degreeing.html

 

[khartley]

I have that link bookmarked, I just wasn't 100% sure if it all applied to me or not.